大人気定番商品 41EXYTjNp4L._BO30,255,255, Kitchen&BathFixtures

• Surface Treatment: Nickel chromium (Ni-Cr) plating.
• Compatible Product Numbers: BF-27A (1000), BF-27B (400) - PU, BF-27A (600), BF-27B (600) - PU,
  Kitchen&BathFixtures Grab Bar for Tub and Shower, Polished Straight Grab Bar, Home Bathroom Balance Bar, Handrail for Handicapped, Ai for Daily Life of Handicapped Elderly
  BF-27A (800), BF-27B (650) - PU, BF-27B (1000) - PU, BF-27B (800) - PU,
  グラブレール、家庭用浴室安全ハンディキャップグラブバー、浴室ガーブバーバリアフリー手すり吸盤ドアハンドル老人滑り止めグラブバー静電防止
  BF-27B (1000) - TO, BF-27B (800) - TO, BF-27B (1200) - PU, BF-27BW (1000) - PU.
• Manufacturer Part Number: A-3682/NC.
• Note: Please make sure to check the diameter of the slide bar you are using.The diameter of the slide bar to which this part is attached is 1 inch (24 mm). *This part cannot be used in case the slide bar used in unit baths, etc. has a diameter of 1.2 inch (30 mm). Slide hook with a 1.2 inch (30 mm) diameter of the grip bar has the part number CKNB (5) - SF. This part is an alternative to part number A-1618.The direction to hang the shower head changes from “front” to “side”.

Shower hook for slide bar.

How to Replace:
(1) Insert a flat precision screwdriver into the gap, pry open and remove the bracket cap.
(2) Use a screwdriver to remove the mounting screws on the bracket.
(3) Pull one bracket out of the pipe.
(4) Pull out the existing hook body from the pipe, then insert the new hook (with the large hole on top).
　*The "bottom" sticker is attached.
(5) Insert the removed bracket into the pipe.
(6) Align the bracket mounting hole with the screw hole, tighten the screw and attach the cap.
(7) Turn the spindle clockwise until it stops.If it is difficult to turn it, please temporarily attach the handle and turn it.
(8) Temporarily attach and operate the handle, check where the hook body can be firmly fixed, then fix the handle with screws.
(9) Install cap A and cap B respectively.
　*The hook part rotates 360°.The hook part has an upper and lower part; rotate the hook part such that the “lower” seal is at the bottom.